The OB loudspeaker system divided into two "boxes" - The small baffle holds two mid-range
ceramic drivers Accuton C² 90-T6 and the tweeter is a modified ribbon driver
Aurum Cantus G3.
The larger H-baffle holds four Tymphany LAT700 (=LAT 2800) which performs the bass.
The effective piston area is 4 x 820cm² = 3280cm² !...in each side...equals five 18" drivers total !
The Amplifier Tower on the right is a 3-way mono chassis with only one PA3CC amplifier module supplied
from a 1500VA toroidal transformer and our PSU12SA. The digital crossover is of course our DCN24. The remaining
three output channels is taken out of the box via RCA connectors.
Measurement of the "LAT2800" close field with no correction or crossover filtering. The frequency response shows
a reasonable linear output to about 500 Hz.
The same measurement - but a 220 Hz/4th order low-pass has been added. To equalize the dipole drop off
a 12dB/octave shelving has been added from approximately 80 Hz. A sharp cut at 15 Hz/24 dB remove the very
low subsonic frequencies.
Jan has promissed more information about his project in the near future...
|